This change adds domain-id support for new
targets. This change involves adding information
to the SCM call currently in use such that it is
a superset, and the additional fields needed are
the IFE and CDM number being used, and VC mask.
These are in addition to existing PHY mask selection,
and lane/trio mask selection.
All the information above will be sent over from CSID
to the PHY driver, and the PHY driver will pack the
information in a generic format before sending it
over in an SCM call. Where previously, this information
is packed in format that matches the register, this
will be sent generically moving forward.
Given that there are multiple instances per physical
PHY hardware, and that the usual dev_handle used by
userspace to identify them are not accessible CSID
side, the lane_assign/lane_cfg parameter is used to find
the specific PHY instance used in conjunction with the
CSID instance in a session. lane_assign from PHY driver
and lane_cfg from CSID have the same values.
CRs-Fixed: 3259706
Change-Id: Ie050b1b9e742c6a63812eb38db7eca76db24667f
Signed-off-by: Li Sha Lim <quic_lishlim@quicinc.com>
Trigger cdm reset to test irq line on presil platforms.
Use below command to trigger after boot up.
echo 1 > /d/camera/cdm/test_irq_line
IRQ line verification can also be done at bootup if
CONFIG_CAM_TEST_IRQ_LINE_AT_PROBE is defined during
compilation.
Both above are valid if CONFIG_CAM_TEST_IRQ_LINE is
enabled during compilation.
CRs-Fixed: 3071027
Change-Id: I9e8c559cd954dfdcfc9b536366e622a03efe1672
Signed-off-by: Pavan Kumar Chilamkurthi <quic_pchilamk@quicinc.com>
Add support to dump the cdm core debug registers and CDM hang detect
support for better debugging purpose in case of cdm timeout at config
ife. Add a debugfs for CDM command buffer dump for cdm hang events.
Fix the possible NULL derefernce while dumping the cdm registers.
Turn on debugfs using following command in adb shell:
echo 1 >> /sys/kernel/debug/camera_isp_ctx/enable_cdm_cmd_buffer_dump.
CRs-Fixed: 2748715, 2782720, 2770565
Change-Id: Ibb9aa1d232d742ca1b6e64c16e9718bfc0bc8624
Signed-off-by: Jigar Agrawal <jigar@codeaurora.org>
msm: camera: tfe: Fix variable initialization issues
msm: camera: isp: Dual tfe event check with proper hw idx
msm: camera: smmu: Add support for non-contiguous mermory region
msm: camera: smmu: Use iommu best match algo for camera
msm: camera: ope: Optimize allocation of IO configuration
msm: camera: ope: Fix for KW Issues
msm: camera: ope: Add support for stripe level height configuration
msm: camera: tfe: Enable the delay line clc
msm: camera: ope: Fix false alarm for OPE HW timeout
msm: camera: tfe: Support register dump per request
msm: camera: ope: Increase max number of stripes
msm: camera: ope: Change packer and unpacker format in case NV12
msm: camera: tfe: Add packet code get command for tfe
msm: camera: ope: Trigger recovery in case of violation on write bus
msm: camera: ope: Protect ope hw reset with mutex
msm: camera: ope: Add a check for valid request in cdm callback
msm: camera: ope: Remove the BW & clock vote in release context
msm: camera: ope: Reduce OPE BUS memory
msm: camera: ope: Fix return value for ope acquire
msm: camera: ope: Fix false alarm for OPE request timeout
msm: camera: ope: Avoid deadlock during recovery after HW hang
msm: camera: tfe: tfe debug enhancement
msm: camera: cdm: Fix irq_data value in case of inline irq
msm: camera: flash: Switch off flash on provider crash
msm: camera: ope: Initialize ope hw mutex structure
msm: camera: cdm: Flush all available FIFOs during reset
msm: camera: cpas: Add mandatory bw option for axi ports clocks
msm: camera: ope: Use vzalloc to allocate the write bus ctx structure
msm: camera: ope: Fix handling of init hw failure
msm: camera: tfe: Enable per frame register dump for rdi only context
msm: camera: cdm: Protect cdm core status bits with mutex
msm: camera: cdm: correct the error check in cmd submit irq
msm: camera: ope: Fix unclock access during HW reset
msm: camera: ope: Program frame level settings after idle event
msm: camera: ope: Delay releasing of resources for last context
msm: camera: isp: Increase default SOF freeze timeout
msm: camera: smmu: Add map and unmap monitor
msm: camera: isp: Add trace events across ISP
msm: camera: smmu: Profile time taken for map, unmap
msm: camera: ope: Start context timer on receiving new request
msm: camera: tfe: Reduce stack size during set axi bw
msm: camera: cdm: Check for HW state before dumping registers
msm: camera: ope: Reduce stack footprint during acquire
msm: camera: tfe: Disable clock if tfe2 is not supported
msm: camera: cdm: Avoid cdm pause incase of BL submit
msm: camera: tfe: Optimize CSID IRQ logging
msm: camera: ope: Move request id validity check outside of lock
msm: camera: tfe: Correct the tfe hw manager dump logic
msm: camera: ope: Synchronize flush and submit BLs
msm: camera: cdm: Protect cdm reset status
msm: camera: cdm: Handle cdm deinit sequence properly
msm: camera: tfe: Reduce reset timeout to 100ms
msm: camera: ope: Fix hang detection
msm: camera: ope: Make non-fatal logs as debug and info logs
msm: camera: tfe: set overflow pending bit to zero after HW reset
msm: camera: ope: Do not disable CDM during error handling
msm: camera: ope: Add support for OPE Replay
msm: camera: ope: Stop OPE in case of init failure
msm: camera: ope: Synchronize process cmd and flush request
msm: camera: cdm: Fix CDM IRQ handling
msm: camera: tfe: LDAR dump for TFE
msm: camera: ope: Fix the length check for debug buffer
msm: camera: cdm: Fix CDM reset logic
msm: camera: ope: Dump debug registers in case of HW hang
msm: camera: tfe: Support the RDI bus port for line based mode
msm: camera: cdm: Handle out of order reset done events
msm: camera: ope: Consider other contexts during timeout
msm: camera: ope: Put GenIRQ in last stripe BL
msm: camera: tfe: Process the rdi interrupts for rdi only resource
msm: camera: jpeg: Check the HW state before accessing register
msm: camera: csiphy: Update csiphy power-up sequence for lito v2
msm: camera: cdm: Secure freeing of request lists using locks
msm: camera: cpas: Add support for Scuba camnoc
msm: camera: csiphy: Clear secure phy flags on release
msm: camera: tfe: validate the tfe bw num paths
msm: camera: ope: Reorder the reset order in ope acquire
msm: camera: ope: Dump debug registers in case of reset failure
msm: camera: ope: Add logic to detect hang in CDM
msm: camera: isp: Increase max count of cfg to support more init packets
msm: camera: core: Fix cpas axi clk rate overflow.
CRs-Fixed: 2668666
Change-Id: I882ca4bd117bebc7d1c62bc82299d69d7b5c9388
Signed-off-by: Trishansh Bhardwaj <tbhardwa@codeaurora.org>
In cdm hw unbind, smmu handle is destroyed before handler is
unset. Also, mutex unlock is unbalanced during error case. Fix
invalid unset handler call and unbalanced mutex in component
unbind for hw cdm.
CRs-Fixed: 2584631
Change-Id: I8e117ce9623ba631d9457ef851b8f271591091b6
Signed-off-by: Mukund Madhusudan Atre <matre@codeaurora.org>
Due to the asynchronous nature of platform probes, inter
dependency between drivers needs to be taken care during
kernel boot up. Component helper provides the facility of
adding matching drivers in a list ordered in the way we want
to bind those drivers. The CRM driver acts as component master
to make sure all slave drivers are bound before it returns
from its own bind call. Add support for serializing platform
probes through component framework.
CRs-Fixed: 2584631
Change-Id: I345da1d2b9cccf6021ac6fc899143013b7714ec4
Signed-off-by: Mukund Madhusudan Atre <matre@codeaurora.org>
Different CDM hardware have different capability and registers.
With old register space, handling new features and operations
would have been a complex task. This change takes care of old
version of CDM and also changes the regspace to provide every
register's access to CDM.
This change further adds support for "arbitration" in case of
multi-context CDMs.
Exports reset functionality to clients, detection of CDM hang.
Flushing the CDM requests and dumping the FIFO content for all
contexts.
It also adds submitting "debug_gen_irq" as BL_done IRQ is only
an indication for availability of FIFO's. The AHB operations
are completed can only be known if the added "debug_gen_irqs"
gets executed and are received by the CDM.
CRs-Fixed: 2594541
Change-Id: I9846b1c5320ba652c5d3b7d83d616d2dabc843e1
Signed-off-by: Abhilash Kumar <krabhi@codeaurora.org>
Signed-off-by: Trishansh Bhardwaj <tbhardwa@codeaurora.org>
Currently camera modules platform registration/remove function
is being called as a part of module_init function individually.
Building camera as module, current infrastructure cannot support
it, as DLKM only support single module_init/exit function.
This change enables that support by combining all platform
entry/remove functions centrally. Also, remove all submodule
makefiles and combined into one root makefile in order to generate
single kernel object file to dynamically loading the kernel module
in case of DLKM compilation.
CRs-Fixed: 2569808
Change-Id: I59db3ed6cef60123e474db2f222c39836056bd6e
Signed-off-by: Jigarkumar Zala <jzala@codeaurora.org>
Signed-off-by: Karthik Jayakumar <kjayakum@codeaurora.org>
Bring over camera driver changes as of msm-4.19
commit 5a5551a7 (Merge "msm: camera: reqmgr: Fix CRM
shift one req issue").
Change-Id: Ic0c2b2d74d1b3470c1c51d98228e312fb13c501a
Signed-off-by: Jigarkumar Zala <jzala@codeaurora.org>
